Basic Car Audio installing

i wasn’t really sure if i should post this cuz it’s really boring but this is away to install wiring in a civic through the firewall and into the trunk, it’s not an indepth install or overview but you get the idea, part two will show where the RCA’s Go in the HU and the remote wire and the install of the inline fuse holder. I’m well aware that most know how to do this but i’ve been asked to do this vid to help ppl out, be sure to comment and subscribe for part 2

HERE’S THE Equipment:
(2) 4″ Rockford Fosgate FNP2514 Speakers
(2) 6 1/2″ Rockford Fosgate P162S Mids
(8) Rockford Fosgate P162S Tweeters
(2) Rockford Fosgate Punch 6×9’s
(1) Rockford Fosgate 1 Farad Capacitor
(1) Rockford Fosgate P2002 Amp
(2) Rockford Fosgate P3 Subs
(1) 1.2 Farad “CAP” Brand Capacitor
(2) Alpine MRP-M500 Amps
4 gauge wiring Panasonic HU

Door and Rear speaker Total
410rms / 820watts total

Sub Total
1000rms / 2000watts
Total Amp Power
1200rms

Duration : 0:2:3


Technorati Tags: , , , , , , , , , , , , , , , , , , , , , , , , , , ,

Tags: , , , , , , , , , , , , , , , , , , , , , , , , , , ,

This entry was posted on Thursday, April 1st, 2010 at 7:06 pmand is filed under Installing Car Audio. You can follow any responses to this entry through the RSS 2.0 feed. You can leave a response, or trackback from your own site.

4 Responses to “Basic Car Audio installing”

  • BIGGIEDEVIL Says:
    April 1st, 2010 at 7:06 pm

    thanks man its hard …
    thanks man its hard 2 get time 2 do anything with the new baby here

  • BIGGIEDEVIL Says:
    April 1st, 2010 at 7:06 pm

    @kenwood1609 it’s …
    @kenwood1609 it’s only 4 gauge so it fit just barely

  • kenwood1609 Says:
    April 1st, 2010 at 7:06 pm

    Good job man i had …
    Good job man i had to pull out my seats and run the wire under the carpet lol it was to big for the trim.

  • ArmoredPersonel48698 Says:
    April 1st, 2010 at 7:06 pm

    Good to see you …
    Good to see you back at it bro!

Leave a Reply